CONTACT US
Flexible Solar Panel

Determine The Allowable
Installation Location and Area

You first need to consider covering the ship's solar power system in thelocations where it is allowed to be installed (e.g., roof, deck). Not everyspace on a ship can be covered with solar panels, nor can you decideon an arbitrary number of installations.You need to depend on the actualsituation of the boat. Some boaters will install solar panels on the sternor the deck of the boat. Some people install solar panels at the mast of asailboat. Sunray customizes the size and power of the solar panels tosuit your needs.

How Solar Panels Work?

Flexible solar panels use photovoltaic cells to convert sunlight into electricity.And charge the batteries through a controller,
the battery stores the energy. lt provides an auxiliary source of electrical energy for the RVs,trucks,and boats.
Batteries /DC power also can be converted to AC via an inverter to power more electrical equipment.

Save Energy

It is worth emphasizing that the main fuel for powering a boat /rv/off-road vehicle is still fuel oil. but solar power provides a relatively low share of the total electricity,not more than 15%.
However,solar panels can continuously power the batteries at almost no cost,reducing your energy consumption.

Using seamless lamination technology

Simple installation

Most installations only require glue/tape instead of drilling holes on the roof, so you don't have to worry about your roof being damaged. It can be installed on flat or slightly curved surfaces. The service life is over 8 years.

You may have some doubts whe using/install solarpanels or before buying solar panels, here are somefrequentlyasked questions about flexible solar panelsIf you have any further questions, please feel free tocontact us.

More FAQ
A: Yes, there are bypass diodes in the junction box.
A: Yes, but you need check that the voltage of the portable power station is within range first. No need to connect the controller.
A: The flexible solar panel has an IP67 rating which means it can withstand water, dust, and other elements.
A: The plastic back sheet can be curved to a maximum 30 degree arc and mounted on RV, boat, cabin, tent, car, trucks, trailers flat surface or any other curved surface.
A: Modules must be mounted using seal with sealant adhesive on the backside of the panel, grommets are only to be used for non-mobile applications.

If there is sunlight, there is electricity



Are you still worried about the lack of power on the road or at night when you are traveling outdoors?Please feel free to consult us for installation precautions and local policy information

Free Consultation
  • +86 18689228784